T1 Cam Trigger Kit

This trigger system is currently available for Honda B series motors, but custom applications are possible as well.

The use of this kit allows you to change from the factory honda mag sensors in the distributor to a more precise digital signal from this sensor. Many aftermarket ecus read the Hall signal much better than they do the oem signal from the distributor. A lot of times you'll notice a smoother idle & much smoother power at high rpm. This also allows complete removal of the factory distributor when a multi channel CDI box & individual coils are used with it. If you want to keep a single channel ignition box & the distributor, then this setup can still be used. These signals are on the input side of the ecu, while the ignition system is on the output. Any combination of ignition box/coils will work.
The standard kit consists of 1 Golden Eagle cam gear that's been machined & custom fit with rare earth magnets installed in it, 1 Dual Pole hall sensor & it's mating conncector, the billet sensor bracket, & installation instructions.

Pricing:
Standard B series kit - $549
B series kit with matching intake cam gear - $649
Standard kit without sensor bracket - $495
Standard H22 kit without sensor bracket - $525
Standard H23 kit without sensor bracket - $495
Standard F23 kit without sensor bracket w/ Bisimoto cam gear - $579
Custom wire harness for cam trigger kit- $40
*harness is built w/ 4 conductor shielded wire, loomed and ready to splice in at ecu


Individual Parts:
Golden Eagle cam gear (not machined) - $109
Dual Pole Hall Sensor - $149
Custom Rare Earth magnets - $8ea.
Billet Sensor Bracket - $95

We also offer M&W CDI ignition systems to compliment this trigger setup. We have a single channel (still uses distributor for spark distribution), a 2 channel (runs in a wasted spark setup on a 4 cyl.), and a 4 channel (direct individual coil firing - the best option).

M&W Pro-10 - $559 - single channel
M&W Pro-12 - $679 - 2 channel
M&W Pro-14 - $899 - 4 channel
T1 Pro 10 Kit - $749 which consists of an M&W Pro 10, a Crane PS92 coil, and a custom wire harness.

Please call or email us to place an order. tony@t1racedevelopment.com or 214-607-9022

DOWNLOAD:

Installation Instructions can be found here HERE