T1 GTR Boost control solenoid kit

Details

T1 4 port boost control solenoid, T1 mounting bracket, 3 brass barb fittings and 1 filter. Term with EV1 male connector for PNP connection with OE boost control wiring.

Plumbing instructions:
Port A – goes to the top of the gates
Port B – goes to the bottom of the gates
Port In – pressure in from turbo
Port Ex – exhaust vent, leave as supplied

$120.00

Details

Frequently Asked Questions About the T1 GTR Boost Control Solenoid Kit

How does the T1 4-port solenoid improve upon the stock GTR boost control?

The 4-port design allows for a much wider range of boost targets, enabling you to run lower spring pressures for traction while still achieving very high boost levels.

Is this solenoid kit a direct plug-and-play solution for the R35 GTR?

Yes, the solenoid is terminated with an EV1 male connector, allowing it to plug directly into the original equipment (OE) boost control wiring without cutting or splicing.

Where do I connect the 'Port A' and 'Port B' lines during plumbing?

For proper operation, route the line from Port A to the top of your wastegates, and connect Port B to the bottom ports of the wastegates.

Do I need to attach a line to the 'Ex' port on the solenoid?

No, the 'Ex' port is the exhaust vent. It comes with a filter installed and should be left as supplied to vent air pressure to the atmosphere.

Does the kit include the necessary hardware for mounting?

Yes, the kit comes complete with a T1 custom mounting bracket, three brass barb fittings, and the filter, ensuring you have everything needed for a clean install.